FBM_LED_Controller_2er β Operating Instructions
The LED Dimmer from 040 Parts is designed for the VW T5/T6 California and is described in the operating instructions in German, English, French and Spanish. The set consists of the dimmer/receiver, designed as a compact adapter cable with plug and socket, plus an infrared remote control. The dimmer is intended exclusively for vehicles with a 5β24 V on-board power supply and for use in dry interior spaces; installation should be carried out by qualified personnel. Before installation, the engine and lighting are switched off and the corresponding fuse is removed to ensure the circuits are de-energized. The cover glass of the lamp is then carefully pried out with a small screwdriver, the housing locking mechanism behind it is released, and the housing β if needed β is lifted out of the fitting from the outside. The connector between the vehicle and the LED is pressed in and pulled out on both sides, then the LED Dimmer is placed between the vehicle plug and the socket of the LED lamp β the connectors are protected against reverse polarity and being mixed up. Cables and dimmer can be wrapped in cloth or foam to prevent rattling, after which the cover glass clicks back into place. After removing the battery insulating strip, the remote control operates Standby, Bright +/β, the preset levels 100 %, 50 %, 25 %, 10 %, as well as 1 min fade-in and 2 min auto-off.